Contents|Index|Previous|Next

Breakpoints and exceptions

Some languages, such as GNU C++, implement exception handling. You can use GDB to examine what caused your program to raise an exception, and to list the exceptions your program is prepared to handle at a given point in time.

catch exceptions
You can set breakpoints at active exception handlers by using the catch command. exceptions is a list of names of exceptions to catch.

You can use info catch to list active exception handlers. See Information about a frame.

There are currently some limitations to exception handling in GDB:

If you call a function interactively, GDB normally returns control to you when the function has finished executing. If the call raises an exception, however, the call may bypass the mechanism that returns control to you and cause your program to simply continue running until it hits a breakpoint, catches a signal that GDB is listening for, or exits.

You cannot raise an exception interactively.

You cannot install an exception handler interactively.

Sometimes catch is not the best way to debug exception handling: if you need to know exactly where an exception is raised, it is better to stop before the exception handler is called, since that way you can see the stack before any unwinding takes place. If you set a breakpoint in an exception handler instead, it may not be easy to find out where the exception was raised.

To stop just before an exception handler is called, you need some knowledge of the implementation. In the case of GNU C++, exceptions are raised by calling a library function named __raise_exception which has the following ANSI C interface:

/* addr is where the exception identifier is stored.
ID is the exception identifier. */
void __raise_exception (void ** addr, void * id);

To make the debugger catch all exceptions before any stack unwinding takes place, set a breakpoint on __raise_exception (see Breakpoints; watchpoints; and exceptions ).

With a conditional breakpoint (see Break conditions) that depends on the value of id, you can stop your program when a specific exception is raised. You can use multiple conditional breakpoints to stop your program when any of a number of exceptions are raised.

© 2004 Red Hat, Inc. All rights reserved. About Red Hat  :  Legal statement  :  Privacy statement  :  Contact Red Hat